Top 10 playstation 3 console Frequently Asked Questions Your own solution

Add a comment

Playstation3 Common red, blue, Yellow Light of Death, red light, crash, no signal, not connected. . . Have you encountered those problems? In fact, there are some ps3 faults that we can solve on our own.

1: PS3 boot fan wind. Most of the silicone grease in the GPU and CPU iron is dry, and the fill can be turned on.

2: PS3 fat machine four USB or two USB interfaces are easy to appear yellow light, yellow light does not mean that the GPU or CPU is bad: first test the GPU CPU instantaneous voltage, there is no 1V voltage, if any, touch by hand The GPU CPU, that low temperature is the problem.

3: PS3 yellow light. Repair first test whether all the inductors on the board have power at any moment, and there is a chance to basically correct the GPU 70% CPU%30.

4: A red light appears within 1 second of the PS3 boot. Generally, the motherboard 12V voltage is short-circuited, and the key test is 12V capacitor and MOS tube.

5: PS3 motherboard repair. Clock reset circuit rarely has problems. It can be said that there will be no problem. Many motherboards are rarely seen. You can eliminate them when repairing.

6: PS3 HDMI has no signal output. First test the PS3 AV port can not be used, most of them are HDMI chip broken will lead to short circuit

7: PS3 yellow light. Repair first boot to see how many seconds off the indicator light for about 4 seconds is basically caused by GPU soldering. Replace the GPU soldering station on the temperature of 240 degrees, the temperature is 270 degrees, 4-5 minutes can be taken down.

8: PS3 brush dead Change bricks cause black screen No second sound can be repaired, use the programmer to read the original program, brush into the modified program to enter. Similar to the computer motherboard brush BIOS.

9: PS3 black screen The motherboard has no 12V voltage output. This phenomenon can be replaced by a short circuit of many HDMI chips. 12V will come out.

10: PS3 crash, PS3 flower screen, PS3 card machine and other phenomena, are GPU problems, welding GPU, especially pay attention to temperature control is very easy to blow.

11: PS3 USB does not recognize the U disk or the link does not touch the handle. Measure whether the USB interface has 5V voltage. If you change the 8-pin MOS tube, you can directly replace the south bridge to solve the problem.

12: PS3 does not read the disc, you can change the optical head. If you change the entire optical drive, you need to use the code, or use the original optical drive board.

13: PS3 does not start, measure the power output has no standby 5V without power supply, there is no red light standby, EC circuit is broken, can not be replaced should EC CPU BIOS is a pair unless the brush program or the whole set can be solved.

14: The PS3 handle is not connected wirelessly. Many of the Bluetooth modules are broken and can be replaced.

15: The PS3 cannot be connected to the network, and the NIC module is directly replaced. Others rarely have problems.

16:PS3 slim machine has a blue screen, and the direct change of the network card module may also be a bad South Bridge.

17: PS3 fat machine appears red screen, brush the BIOS program.

18: PS3 downgrade, 20 25 thin machine brush BIOS program, all PS3 thick machine can brush homemade system, PS3 3000 PS3 4000 to play hard disk game brush homemade system needs to add crack module to re-line

19: PS4 brush homemade system: At present, only the authentic game emperor can be played, and there is no cracking technology.

Playstation3 Common red, blue, Yellow Light of Death, red light, crash, no signal, not connected. . . Have you encountered those problems? In fact, there are some ps3 faults that we can solve on our own.

Leave a comment